Installation on render (mortar group PII and PIII to DIN 18550)
All cement-based renders beneath ceramic tiles or natural stone are to be struck off tightly with a straight edge. The surface must remain rough and may not be smoothened or felt boarded. To enable an orderly tile installation, increased requirements for flatness of the render should be stipulated.
|
PRIMING
|
|
|
Solvent free universal primer, water and alkali resistant
|
|
|
|
LEVELLING
|
|
|
Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm
|
|
|
|
Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques
|
|
|
|
WATERPROOFING
|
|
|
Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas
|
|
|
|
One component flexible waterproof slurry, wall/floor
|
|
|
|
Fabric reinforced sheet style bonded waterproof membrane
|
|
|
|
TILE INSTALLATION
|
|
|
Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques
|
|
|
|
Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use
|
|
|
|
Flexible adhesive mortar with good slump resistance
|
|
|
|
Flexible natural stone adhesive
|
|
|
|
GROUTING
|
|
|
Simple to use grout, up to 6 mm joint widths
|
|
|
|
Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1 to 10 mm joint widths, with FAST TECHNOLOGY
|
|
|
|
Silicone sealant for movement joints
|
|
|
|
Silicone sealant for discolouration-free elastic jointing
|
|
|
