Installation on old tiled finishes
The existing tiled finish must be sound and load bearing. Remove loose areas and repair with MGIII cement mortar. The substrate must be cleaned and all adhesion inhibiting components such as e.g. lime, grease, dirt etc must be removed. Resin repair cracks in the substrate with a reaction resin. Abrading the old tiling increases the bond of the primer or scratch coat.
|
PRIMING
|
|
|
Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates
|
|
|
|
Flexible mineral-based waterproof slurry as a scratch coat
|
|
|
|
WATERPROOFING
|
|
|
Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas
|
|
|
|
One component flexible waterproof slurry, wall/floor
|
|
|
|
Fabric reinforced sheet style bonded waterproof membrane
|
|
|
|
TILE INSTALLATION
|
|
|
Grey, highly flexible adhesive for interior and exterior use
|
|
|
|
Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use
|
|
|
|
GROUTING
|
|
|
Simple to use grout, up to 6 mm joint widths
|
|
|
|
Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY
|
|
|
|
Silicone sealant for movement joints
|
|
|
|
Silicone sealant for discolouration-free elastic jointing
|
|
|
